PrecisionMaster

Precision Master Overview:
The Precision Master cutting system will boost your shop’s productivity and consistency, while reducing material waste by as much as 30%. With a traverse speed of up to 1000 inches per minute, you have the ability to maximize production without the loss of floor space. The compact design of the Precision Master also enables it to be easily moved and set up at a different location. This is truly a high powered, compact, cutting machine.
Cutting Table
Cutting Area:	6.6ft x 10ft (2m x 3m) ranging to 6.6ft x 20ft (2m x 6.1m)
	Other lengths optional; 2 piece construction for 20ft table only
Positioning Accuracy and Speed:	+/- 0.005" at 1000 IPM maximum traverse speed
Torch Height:	Hypertherm Command THC or Kaliburn Inova
Ventilation:	Zoned Down Draft Table with automatic damper control
Sheet/Part Support:	Removable slat supports; Replaceable slats
Drive System	Planetary Gearbox with 800 watt dual side drive AC servos
Table Strength	Full table capacity of 1 inch plate
Table Type	Unitized, single piece

Cutting Table Controller
Controller Type	PC based
Hard Drive Capacity	2.0 Gbyte minimum
Speed	566 MHz Pentium processor with 256 Mbytes RAM
Communication Interface	Optically isolated serial port with programmable baud rates to 115K
Parametric Library	40 preprogrammed shapes with over 300 variations
Part/Sheet Storage Ability	yes
Program Format	EIA (G-Codes)
Automatic Part/Plate Alignment	yes
Stand-alone Capability	yes

Plasma Power Unit
Hypertherm
	•Arcwriter
	•HD 4070
	•HPR 130
	•HPR 260
	•HPR 400XD
Kaliburn
	•Proline 2200
	•Spirit 150a
	•Spirit 200a
	•Spirit 275a
	•Spirit 400a